On this page
Bill of Materials
The materials needed for the project is:
- PCB
- 3D printed chassis
- ESP32 C6 Supermini
- Motor driver: L298N
- Ultrasonic sensor: HC-SR04
- IR sensor: v183
- Cables
Soldering the PCB
The order which we recommend is
- Pins on Buck-boost converter and corresponding headers on the PCB. (4 single pins)
- Pins on ESP and headers on PCB (2 x 10 pins)
- Switch directly through PCB (hard to reach!) and or on wires
- Pins and headers for motor driver (4 pins + 2 pins)
- Header for the sensors (10 pins)
- Battery-holder (2 plates)